SMARC-FiMX7 Computer on Module
10+ Years Product Life Cycle !!
Technical & Documents Support in the product tabs.
Electronics Attributes
Form Factor 82 mm x 50 mm by SMARC Specification
Compliance SMARC 2.0
Power Supply 3V to 5.25V
Power Consumption Solo Core (512MB DDR3L): 0.9W, Dual Core (1GB DDR3L): 1.2W
Environment Attributes
Extended Temperature Operating Temperature Range: -20°C ~ 80°C Storage Temperature Range: -40°C ~ 100°C Junction Temperature Range: -40°C ~ 100°C
Humidity 10% ~ 90% relative humidity, non-condensed

Write a review

Note: HTML is not translated!
    Bad           Good
Please go to Embedian Development Site for how to configure, build and install all software packages.
Yocto Project can go to Building TI/Embedian's Arago SDK Distribution for more details.
It is recommended to read our FAQs during development. 

SMARC-FiMX7 Computer on Module


◆ NXP i.MX7 Cortex-A7 Solo 800Mhz and Dual Core 1GHz

◆ 1GB (Dual) or 512MB (Solo) DDR3L,

    8GB eMMC Flash, 1x SDIO

◆ 24-bit dual-channeled LVDS up to 1080p

◆ 2 x GBE LAN w/AVB

◆ 2 x CAN, 4 x UART, 5 x I2C, 1 x I2S,1 x PCIe(Dual only), 

    12 x GPIOs, 2 x SPI, 2-LANE Serial Camera Interface

◆ Model Description:

  • SMARC-FimX7-S: Solo Core i.MX7 running at 800Mhz, 512MB DDR3L
  • SMARC-FimX7-D: Dual Core i.MX7 running at 1GHz, 1GB DDR3L ( +$10.00 )

※ Evaluation Baseboard: EVK-STD-CARRIER-S20

Datasheet download
Technical Information:
Part No. SMARC-FiMX7-X

 NXP (Freescale) i.MX 7

 Solo or Dual Core

 1GHz (Dual Core) or 800Mhz (Solo Core)


 1GB DDRL (Dual Core)

 512MB DDR3 (Solo Core)

 8GB eMMC (5.x) onboard

 4MB SPI NOR Flash onboard

 AT24C32 EEPROM onboard

Graphic Controller

ePxP (Enhanced PiXel Processing engine to offloading key pixel processing)

Up to 1080p full HD resolutions

Display Interfaces

Single channel 24 bit LVDS LCD or dual channel 24-bit LVDS LCD

  • Panel support signals (I2C, Power Enables, PWM)
  • 2nd LVDS channel is defined on SMARC 2.0 interface
MIPI/ Serial Camera Interfaces Serial configuration: CSI (2-lanes)
SDIO Interfaces

 One SDIO interfaces

  • 4 bit SDIO card interface with support lines
  • 8 bit eMMC interface with support lines
SPI InterfacesTwo SPI interfaces with 2 chip selects on each SPI channel
I2S Interfaces

One I2S interface

  • Typically used for connection to I2S audio CODECs
I2C Interfaces

 Four I2C interfaces

  • Power Management
  • General Purpose
  • Camera
  • LCD Display ID
Asynchronous Serial Port (UART) Interfaces

 Four asynchronous serial ports

 Two with 4 wire handshake (RXD, TXD, RTS#, CTS#)

 Two with data only (RXD, TXD)

 Logic level signals

CAN Bus Interfaces

 Two CAN bus interfaces

  • Logic level signals from Module based CAN bus protocol controllers
  • RXD, TXD only
  • Two Module GPIOs are designated for optional use as CAN bus error status inputs
USB Interfaces

Two USB OTG 2.0 Ports with PHY (Only one port with PHY for Solo Core)

USB support signals (VBUS enable / Over-current detects, OTG support signals)

PCI Express

One PCIe x 1 link

PCIe Gen2.1

Reference Clock Pair

Could be configured as PCIe target

Common PCIe wake signal

Gigabit Ethernet (with AVB)

Two analog GBE MDI interface for Dual Core and One analog GBE MDI interface for Solo Core (Qualcomm Atheros AR8035 PHY onboard)

No magnetics on Module

LED support signals

CTREF (center tap reference voltage) for Carrier magnetic

Watchdog Timer

Real-Time Clock

External Seiko S35390A onboard
General Purpose I/O

 Twelve GPIO signals

 Specific alternate functions are assigned to some GPIOs

 PWM / Tachometer capability

 Camera support

 CAN Error Signaling

 HD Audio reset

System and Power Management Signals

 Reset out and Reset in

 Power button in

 Power source status

 Module power state status

 System management pins

 Battery and battery charger management pins

 Carrier Power On control

Boot Source Select

 Three pins to allow selection from Carrier Board

 Select options to include boot from one of the following:

  • Module SPI
  • Module eMMC Flash
  • Module Remote Boot (Network Port)
  • Carrier SPI
  • Carrier SD Card

Power Supply

3V to 5.25V

Operates directly from single level Lithium Ion cells, or fixed 3.3V or 5V power supply
Power Consumption (Typical)

 Solo Core (512MB DDR3L): 0.9W

 Dual Core (1GB DDR3L): 1.2W



Based on NXP (Freescale) imx_4.9.88_2.0.0_ga, imx_v4.9.11_1.0.0_ga or imx_4.1.15_2.0.0_ga

Yocto Project Support

Ubuntu 14.04 and 16.04 LTS or Debian 9 Support


The estimated lead time will be 5 ~10 days. For detailed lead time, please contact us.

  • Views: 9364
  • Brand: embedian
  • Product Code: SMARC-FiMX7
  • Availability: In Stock
  • $74.0
  • 10 or more $72.0
  • 50 or more $70.0
  • 200 or more $68.0
  • 500 or more $66.0

Available Options

Tags: embedded-computer-on-module

Features:◆ SMARC v2.0 Module Compliant◆ SMARC v2.0 module bring-up platform for hardware a..
Features:◆ NXP i.MX8M ARM Cortex-A53 and Cortex-M4 up to 1.5GHz◆ 2GB/4GB LPDDR4 up to 3200MT/s,..
Features:515nm / 520nm Green Line Laser ModuleDimension Siz: D9mm x 36mmVoltage: 2.7~5VDCOutput Powe..
$60.0 $50.0
Features:515nm Small Green Laser ModuleDimension Size: D4.5mm x 8mm(without PCBA)Voltage: 2.7~5VDCOu..
$60.0 $50.0
Features:515nm standard small green laser moduleDimension Size: D6mm x 28mm(with PCBA)Voltage: 2.7~5..
$50.0 $45.0
Features:635nm Standard Small Laser ModuleDimension Size: D4mm x 18mmVoltage: 3VDCOutput Power: 1mW,..
$20.0 $16.0
Features:808nm Infrared Laser Line ModuleDimension Size: D9mm x 25mmVoltage: 3VDCOutput Power: 30mW,..
$14.0 $12.0
Features:850nm Infrared Laser ModuleDimension Size: D6mm x 10mm(without PCBA)Voltage: 3VDCOutput Pow..
$13.0 $12.0